Back to device page

taCidBlu Flasher

Flash the taCidBlu image to your ESP32-C3.

Firmware Package
1.7.W
Full Install – This Will Erase Data
This process completely reflashes the device, including:
  • Bootloader
  • Partition table
  • Main firmware
  • On-device settings and stored data
Only perform a Full Install on a new device, recovery, or when you want a clean reset.

Steps

  1. Use Chrome or Edge on desktop.
  2. Plug in your ESP32-C3 via USB.
  3. Click Connect below.
  4. Choose your device in the popup.
  5. Click Install and wait for completion.

Your browser doesn't support WebSerial. Use Chrome or Edge.

You must load this page over HTTPS.
If flashing fails, try another USB cable, port, or close Arduino/serial tools.